Filter
Top Products
Troubleshooting
22 309295L
Gun Operation Troubleshooting
Problem Cause Solution
Excessive spray fog. Atomizing air pressure too high. Close atomizing air valve some, or
decrease air pressure as low as pos-
sible; minimum 40 psi (0.28 MPa, 2.8
bar) needed at gun for full voltage.
Fluid too thin. Increase viscosity.
“Orange Peel” finish. Atomizing air pressure too low. Open atomizing air valve more or
increase gun air inlet pressure; use
lowest air pressure necessary.
Spray tip is too large. Use smaller tip. See page 46.
Poorly mixed or filtered fluid. Remix or refilter fluid.
Fluid too thick. Reduce viscosity.
Fluid leaks from the fluid packing
area
Worn fluid needle packings or shaft. Replace fluid needle assembly (26);
see page 30.
Air leaks from the front of the gun Air valve (21) is not seating properly. Clean and service air valve; see
page 35.
Fluid leakage from the front of the
gun
Worn or damaged fluid needle ball. Replace fluid needle (26); see page
30.
Worn fluid seat housing (2). Replace seat housing; see page 26.
Loose spray tip (3). Tighten retaining ring (27); see page
26.
Damaged tip seal (3a). Replace; see page 26.
Gun does not spray Low fluid supply. Add fluid if necessary.
Damaged spray tip (3). Replace; see page 26.
Dirty or clogged spray tip (3). Clean; see gun operation manual.
Damaged fluid needle (26). Replace; see page 30.
Dirty air cap Damaged or plugged air cap (9). Clean air cap; see gun operation
manual.