Filter
Top Products
Shutdown and Cleanup
16 313384B
Shutdown and Cleanup
After Spraying
1. Relieve Pressure, page 6.
2. Fill material hopper with 2 - 4 gallons of clean water.
3. Spray inside material hopper to circulate water
through gun and hose. While circulating water, use
gun to clean material hopper.
Spray water into waste bucket to empty material hopper.
4. Follow Pressure Relief, page 6.
NOTICE
• Turn off sprayer if you are going to stop spraying for 5 minutes or longer.
• Before removing material hose, Relieve Pressure and make sure there is no material inside of hose.
• To keep sprayer in good operating condition, always clean it thoroughly and prepare it properly for storage.
• If water freezes in sprayer, damage may occur. During cold weather, store sprayer where it will not freeze.
NOTE: A soft brush can be used to loosen dried-on
material.