Filter
Top Products
G0444/G0444Z 10" Table Saw -11-
G0444Z
110V................................................ NEMA 5-30*
220V (prewired) .............................. NEMA 6-15*
*Not Included
Figure 6. NEMA 5-30 plug and receptacle.
Figure 7. NEMA 6-15 plug and receptacle.
If the circuit breaker trips or the fuse blows regu-
larly, your machine may be operating on a circuit
that is close to its amperage draw capacity.
However, if an unusual amperage draw does not
exist and a power failure still occurs, contact a
qualified electrician.
Always check to see if the wires in your circuit are
capable of handling the amperage draw from
your machine, as well as any other machines that
could be operating on the same circuit. If you are
unsure, consult a qualified electrician.
Electrocution or a fire
can result if the machine
is not grounded correct-
ly. Make sure all electri-
cal circuits are ground-
ed. DO NOT use the
machine if it is not
grounded.
NOTICE
The wire on the power cord with green or
green and yellow striped insulation is the
grounding conductor.
In the event of an electrical short, grounding
reduces the risk of electric shock by providing a
path of least resistance to disperse electric cur-
rent. This tool is equipped with a power cord that
has an equipment-grounding prong. The outlet
must be properly installed and grounded in accor-
dance with all local codes and ordinances.
Because of the high amperage draw from this
machine, we do not recommend the use of exten-
sion cords. Instead, position machines near
installed wiring to eliminate the need for exten-
sion cords.
Extension Cords
Grounding
Circuit Capacity