Filter
Top Products
G0444/G0444Z 10" Table Saw -29-
Before starting the machine:
1. Read the entire instruction manual.
2. Make sure the blade guard and splitter are
installed and correctly adjusted.
3. Make sure all tools and objects have been
removed from the machine.
4. Review Section 3: Circuit Requirements.
5. Keep a finger on the STOP button at all
times during the test run.
Starting the machine:
The Model G0444/G0444Z is operated by a push
button switch that is clearly labeled
START/STOP.
This switch can be locked out by sliding a pad-
lock through the START button (Figure 38b)
when the machine is not in use.
Loose hair and clothing
could get caught in
machinery causing seri-
ous personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses during
assembly.
The adjustments listed below have been per-
formed at the factory and no further setup is
required to operate the machine.
However, because of the many variables
involved with shipping, we recommend at least
check the following adjustments to ensure the
best possible results from the new machine.
All of these adjustments are covered in step-by-
step detail in Section 8: Service Adjustments.
Recommended adjustment checklist:
• Blade Parallelism (page 41)
• 45˚ Blade Stop (page 44)
• 90˚ Blade Stop (page 44)
Recommended
Adjustments
Start Up
Figure 38b. Locked power switch