Filter
Top Products
G0444/G0444Z 10" Table Saw -19-
6. Secure the flat side supports to the stand
legs with 16 carriage bolts, 16 flat washers,
16 lock washers, and 16 hex nuts (Figure
12).
3. Place the long “L” side supports over the
ends of the short “L” side supports.
4. Using a 12mm wrench, secure all four “L”
side supports to the saw body with 4 hex
bolts, 8 flat washers, 4 lock washers, and 4
hex nuts.
5. Secure each stand leg to the outside of the
“L” side supports with 24 carriage bolts, 24
flat washers, 24 lock washers, and 24 hex
nuts (Figure 13).
Figure 13. Stand leg installation.
Figure 14. Flat side support installation.
Components and Hardware Needed: Qty
Rubber Feet........................................................4
Hex Nuts
1
⁄4"-20 ..................................................4
Flat Washers
1
⁄4" ................................................4
Phillips Head Screws
1
⁄4"-20 x 1"........................4
Tools Needed:
10mm Wrench or Socket....................................1
Phillips Head Screwdriver ..................................1
To install the rubber feet:
1. Using a 10mm wrench and a Phillips head
screwdriver, secure each rubber foot to the
stand legs with the Phillips head screws, the
hex nuts, and the flat washers (Figure 15).
2. With the help of an assistant, flip the stand
rightside up.
3. Final tighten all of the stand fasteners.
Rubber Feet
Figure 15. Rubber feet installation.
Stand Leg
Flat Side Support