Filter
Top Products
-16-
G0458 18" Open End Belt/Drum Sander
Handwheel
Components and Hardware Needed: Qty
Handwheel Handle ............................................
1
Handwheel ........................................................
1
Cap Screw M5-.8 x 10 .......................................
1
Flat Washer 5mm ..............................................
1
To install the handwheel:
1. Thread the handwheel handle into the
handwheel and tighten it.
2. Slide the handwheel over the shaft, making
sure the shaft pin (Figure
13) inserts into the
slots in the handwheel.
Figure 13. Installing handwheel.
Shaft Pin
3. Secure the handwheel with an M5-.8 x 10
cap screw and 5mm flat washer.
Dust Port and Bag
Components and Hardware Needed: Qty
Dust Port ...........................................................
1
Dust Bag ............................................................
1
Dust Hose Clamp ..............................................
1
Phillips Head Screw M6-1 x 25 .........................
1
To install the dust port:
1. Slide the dust port over the fan housing and
tighten the included Phillips head screw
(Figure 14).
Figure 14. Installing dust port.
Slots
Fan Housing
Dust Port
Figure 15. Installing dust bag and clamp.
2. Slide the dust hose clamp over the dust
bag, insert the bag and clamp over the dust
port (Figure 15
), and secure with the clamp
handle. DO NOT overtighten the clamping
adjustment or it may break!
Dust Port
Clamp
Dust Bag