Grizzly G0459P Sander User Manual


  Open as PDF
of 56
 


Depth of Cut
        
 

     
 

     

      
       

To set the depth of cut:
1.     Figure 15 




Note: When adjusting the table to sand a
thicker workpiece, lower and then raise the
table to remove backlash from the adjust-
ment mechanism. If the table is lowered too
far, the conveyor belt may rub against the
chain, leaving grease on the belt.
2. ON
Variable SpeedPage 22  
     

      
       

Figure 15.


 previous next