Grizzly G0459P Sander User Manual


  Open as PDF
of 56
 


DO NOT sand more than one board at a time.
Minor variations in thickness can cause one
board to be propelled by the rapidly spinning
sanding drum and ejected from the machine.
NEVER stand directly in front of the outfeed
area of the machine. Failure to do so could
result in severe personal injury.
To sand a workpiece:
1.       
Depth of Cut Page 21
2. ON

3.      
      

4.        
      
      

SandingVariable Speed
 
       
         


         





To adjust the conveyor speed:
1. 
2.      Figure
16      
     

Figure 16.
 previous next