Grizzly G0459P Sander User Manual


  Open as PDF
of 56
 


6. 


7.        
      



8. Step 7
   

      


  
  

      

To adjust the pillow block bearings:
1.      Figure 30 


2. 

      Figure
30
Note: Turn all setscrew sets an equal
amount.
3. 
Steps
1–8
       
      
Do not over tighten the
lock nuts. The pillow block bearings can
break if over tightened.
To adjust the sanding drum perpendicular to
the feed direction (Figure 32):
;ZZY
9^gZXi^dc
.%ß
HVcY^c\9gjb
Figure 32. 
1. 
2. 
       
Figure 33

        

Figure 33. 

3.      
 
       



Note: After you have adjusted the drum, do
not forget to tighten the lock nuts and recheck
the alignment by repeating Steps 1–3.



 previous next