Filter
Top Products
G0474/G0475 Sandblasters
-7-
The Model G0474/G0475 was carefully packed
when it left our warehouse. If you discover the
equipment is damaged after you have signed
for delivery, please immediately call Customer
Service at (570) 546-9663
for advice.
Save the containers and all packing materials for
possible inspection by the carrier or its agent.
Otherwise, filing a freight claim can be difficult.
This equipment pres-
ents serious injury haz
-
ards to untrained users.
Read through this entire
manual to become famil
-
iar with the controls and
operations before start
-
ing the equipment!
Unpacking
Set Up Safety
SECTION 2: SET UP
The following items are needed to complete the
set up process, but are not included with your
equipment:
Description Qty
• Phillips Screwdriver #2 ............................... 1
• Standard Screwdriver #2 ............................
1
• Teflon Tape ................................................
1
• Wrench 10mm ............................................
1
• Wrench 17mm ............................................ 1
• Wrench 22mm ............................................ 1
Items Needed for
Set Up
Sandblasting operations are extremely demand-
ing on some compressors and can cause a com-
pressor overload or overheated condition. Refer
to your compressor Owner's Manual and make
sure that it can handle the load of sandblasting. If
it can, you must follow these setup recommenda
-
tions:
We recommend using a compressor that is 5 HP
and above with a minimum of a 12 CFM rating.
Keep your compressor completely isolated from
your sandblasting environment, or keep the work
area downwind from the compressor. Airborne
abrasive dust will destroy rings, pistons, valves,
and bearings.
Make sure to increase the maintenance interval of
your compressor if using it in sandblasting opera
-
tions.
Compressor