Filter
Top Products
-14-
G0489 Metalworking Sander
Mounting Sander
This step may require three people to complete—
two to lift and hold the sander in place, and one
person to install the hardware.
Components and Hardware Needed: Qty
Sleeve ................................................................ 1
Hex Bolt M12-1.75 X 3
0 ..................................... 1
Hex Nut M1
2-1.75 .............................................. 1
Flat Washers 12mm ..........................................
2
Helpers ..............................................................
2
Angle Adjustment Lever ....................................
1
To mount the sander to the base:
1. Set the base in the upright position.
2. Slide the sleeve through the holes so it spans
the width of the base yoke.
3. With the aid of a couple helpers, lift the sand-
er, spread the yoke on the sander slightly
and set onto the base (see Figure 10).
4. Slide the 30mm bolt and washers through
the sleeve and tighten the nut.
5. Thread the angle adjustment lever through
the slot and tighten the sander in position.
Figure 11. Spark trap installation.
Spark Trap
Knob
Theses components MUST be mounted before
operation.
Components and Hardware Needed: Qty
Spark Trap .........................................................
1
Eye Shield .........................................................
1
Rest ...................................................................
1
Rest Lever .........................................................
1
Square Nut ........................................................
1
Cap Screw M5-.8 x 50 .......................................
1
To mount the spark trap, rest, & eye shield
:
1. Refer to Figures 11-13.
Spark Trap, Rest &
Eye Shield
Figure 12. Eye shield installation.
Cap Screw
Eye Shield
Slot
Figure 10. Base installation.
Sleeve