Filter
Top Products
G0489 Metalworking Sander
-7-
Additional Safety for Belt Sanders
8. FEEDING STOCK. Firmly grasp the
workpiece in both hands and ease it into
the machine using light pressure. DO NOT
jam the workpiece into the machine during
operation. Feed the workpiece against the
direction of rotation. DO NOT sand tapered
or pointed stock with the point facing the
feed direction. Never sand more than one
piece of stock at a time.
9. BELT GUARDS. Use belt guards when the
section of belt is not being used to avoid
unintended contact with the belt. Always
keep door closed during operation.
10. REPLACING SANDPAPER. Replace
sanding paper when it becomes worn.
DO
NOT operate the sander with a damaged or
badly worn sandpaper.
11. MAINTENANCE AND ADJUSTMENTS.
Perform machine inspections and main
-
tenance service promptly when called for.
Disconnect power before performing main
-
tenance or adjustments on the sander.
12. EXPERIENCING DIFFICULTIES. Any
problem, with the exception of convey-
or belt tracking that is concerned with
any moving parts or accessories, must be
investigated and corrected with the power
disconnected, and after all moving parts
have come to a complete stop.
1. RESPIRATOR AND SAFETY GLASSES.
Always wear a respirator and safety glass
-
es while operating the machine. Dust and
chips are created when sanding. Some
debris will be ejected, becoming hazards to
the eyes and lungs.
2.
PROTECT YOUR HEARING. Always wear
approved hearing safety equipment when
operating this belt sander.
3. DUST COLLECTION SYSTEM. Never
operate the sander without an adequate
dust collection system in place and run-
ning. Use only a system rated for metal
dust collection.
4. CLOTHING. DO NOT wear loose clothing
while operating this machine. Roll up or
button sleeves at the cuff.
5. HAND PROTECTION. DO NOT
place
hands near, or in contact with, sanding belt
during operation!
6. HOT WORKPIECES. Friction will cause
the workpiece to heat to the point of caus
-
ing burns to the skin.
7. FLAMMABLE MATERIALS. Sanding
metal will cause sparks. Make sure there
are no flammable or combustible materials
near sander.
No list of safety guidelines can be complete.
Every shop environment is different. Always
consider safety first, as it applies to your
individual working conditions. Use this and
other machinery with caution and respect.
Failure to do so could result in serious per-
sonal injury, damage to equipment, or poor
work results.
Like all machines, there is danger associ-
ated with the Model G0489. Accidents are
frequently caused by lack of familiarity or
failure to pay attention. Use this machine
with respect and caution to lessen the pos
-
sibility of operator injury. If normal safety
precautions are overlooked or ignored, seri
-
ous personal injury may occur.