Filter
Top Products
Figure 11.
Dust Collection
To connect the machine to a dust collector:
1.
Figure 11
DO NOT operate the Model G0495X without
an adequate dust collection system. This
jointer creates substantial amounts of wood
dust while operating. Failure to use a dust
collection system can result in short and
long-term respiratory illness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine
the CFM at the dust port, you must consider
these variables: (1) CFM rating of the dust col-
lector, (2) hose type and length between the
dust collector and the machine, (3) number
of branches or wyes, and (4) amount of other
open lines throughout the system. Explaining
how to calculate these variables is beyond the
scope of this manual. Consult an expert or pur-
chase a good dust collection "how-to" book.
2.
Note: A tight fit is necessary for proper per-
formance.
Figure 12.
Ide9ZVY
8ZciZg
7diidb9ZVY
8ZciZg
Setting Outfeed
Table Height
To set the outfeed table height:
1.
2.
3.
Figure 12
4.
Figure 13.
Figure 13.
HigV^\]iZY\Z
Dji[ZZY >c[ZZY