To adjust the table parallelism:
1.
Figure 46
2. Figure 51
Note:It may help to clean the screw covers
with electrical parts cleaner. Push duct tape
firmly against the cover, then pull straight
up.
Figure 52
Figure 53
3. Figure 51
4.
Figure 47
Figures 52
53
Note:Setting the outfeed table parallel to the
cutterhead within 0.010"-0.012" will produce
high quality results. Going lower than this
number will produce minimal gain.
Figure 51
5.
6.
7.
Figure 49
HigV^\]iZY\Z
Dji[ZZYIVWaZ
>c[ZZYIVWaZ
Figure 54