Grizzly G0495X Saw User Manual


  Open as PDF
of 56
 


Replacing Carbide
Inserts
Tools Needed: Qty
 



      
Figure
55
        


        


To rotate or change a carbide insert:
1. 
2.        

3. 
4.       
   
       

Note:Proper cleaning is critical to achieving
a smooth finish. Dirt or dust trapped between
the insert and cutterhead will slightly raise the
insert, and make noticeable marks on your
workpieces the next time you cut.
5.       
      
  

Note: Excess oil may squeeze between the
insert and cutterhead or in the screw hole,
thereby lifting the insert or screw slightly and
affecting workpiece finishes.
Figure 55. 

8.        
   Figure 50   


 

       

9. 

10.  Setting
Outfeed TablePage 15
11. 
 previous next