Filter
Top Products
Figures
32 & 33
To bevel cut on the jointer:
1. SECTION 1: SAFETY,
Page 7
2.
Stock Inspection & Requirements
Page 23
3.
4.
5.
6.
7.
Figure 32
Note: If your leading hand gets within 4"
of the cutterhead, lift it up and over the
cutterhead, and place the push block on
the portion of the workpiece that is on the
outfeed table. Now, focus your pressure on
the outfeed end of the workpiece while feed-
ing, and repeat the same action with your
trailing hand when it gets within 4" of the
cutterhead. To keep your hands safe, DO
NOT let them get closer than 4" from the
cutterhead when it is moving!
8. Step 7
Figure 33.
NOTICE
If you are not experienced with a jointer,
set the depth of cut to zero, and practice
feeding the workpiece across the tables as
described below. This procedure will better
prepare you for the actual operation.
Figure 32.
Bevel Cutting