Grizzly G0503 Saw User Manual


  Open as PDF
of 76
 


Resawing
8. 
If a second person is
receiving the workpieces, use the return roll-
ers to send them back to the person on the
infeed side.
Figure 34.




Figure 33.




5. 
    Figure 33.  
     

NOTICE
Always de-tension blade after use. Bandsaw
blades will last longer and stretch less if de-
tensioned after each use.
DO NOT cut slices thinner than
1
⁄4" off of
the bottom of the stock. Attempting to cut
thin slices off of the bottom may cause the
blade to cut into the conveyor belt.
To perform a resawing operation:
1.        
Installing the
Blade page 22
2. 


        



     
Six
rotations of the handwheel raises the blade
approximately
1
/4".
3.       


4. 

Figure 33
6. 



7. 

Figure 34
NOTICE
Running the conveyor too fast can push the
blade into the support bearing, grooving the
bearing and causing blade breakage.
 previous next