Tools Needed Qty
Supplies Needed Qty
To drain the hydraulic fluid:
1. Disconnect the resaw from the power
source!
2.
Figure 50
Hydraulic System
Major Service
The hydraulic fluid is hot and under high
pressure when the hydraulic pump motor is
running. Always stop the resaw, make sure
the pressure gauge reads 0 PSI, and make
sure the fluid is cool before servicing.
Figure 50.
Figure 49.
To change the filter:
1. Read and understand the hydraulic safety
instructions on page 11 before continu-
ing!
2. Disconnect the resaw from the power
source!
3.
4. Figure 49