Filter
Top Products
Replacing Conveyor
To replace the conveyor belts:
1.
Figure 64
Figure 64.
2. Disconnect the resaw from the power
source!
3.
Figure 63
4.
5.
Write the number of turns down, so
you do not forget. Remembering this number
is an important part of the re-assembly pro-
cess.
6.
7.
8.
9.
10.
11.
step 5
The new belt may be tighter than the
old one because it has not been broken-in. If
this is the case, deduct one or two turns from
your original number of turns.
12.
“Tracking Conveyor”
page 46