Filter
Top Products
18" & 20" Super Heavy-Duty Bandsaws -13-
Figure 6. Table installed correctly.
Table
To mount the table:
1. Installing the table is easiest if the blade is
out of the way. Remove the blade by first
loosening the blade tension handwheel,
move the blade guide bearings (refer to the
section titled Blade Changes on page 25)
then by sliding it off the bandsaw wheels.
Wear heavy leather gloves to protect your
hands.
2. With the help of another person, lift the table
onto the trunnion.
Blade Tension
Handwheel
The table for this bandsaw
is very heavy. Get help
when placing it on the
trunnion.
Fence
Figure 7. Fence mounted on rail.
To mount the fence:
1. Loosen the lock knob and slide the fence
onto the rail.
2. Slide the fence beyond the center of the
table so the blade can be installed without
blocking the fence as shown in Figure 7.
3. Please refer to the section titled Blade
Changes on page 25 to install the blade.
4. Tension the blade enough to keep it on the
saw so it does not spring off during the rest
of the assembly process.
3. Place the large hex bolt with washer through
the table trunnion mount and the trunnion.
The assembly should now look similar to
Figure 6.
DO NOT connect power
to the bandsaw until
instructed to do so.
Failure to do this may
result in serious person-
al injury.