Filter
Top Products
G0513X/G0514X/G0514X3 Extreme Series Bandsaw
-51-
Wheel Alignment
Figure 62. Dimensions of coplanarity gauge.
Components and Hardware Needed: Qty
60" Long
2x4 ..................................................... 1
Tools Needed:
Wrench 13mm ...................................................
1
Tape Measure ...................................................
1
Coplanarity Gauge (see
Figure 62) .................. 1
Wheel alignment is one of the most critical factors
for optimal performance from your bandsaw.
Heat, vibration, wandering, blade wear, tire wear
and overall bandsaw wear are considerably
decreased when the wheels are properly aligned
or “coplanar.”
Coplanar wheels automatically track the blade
by balancing it on the crown of the wheel. This is
known as coplanar tracking.
To check if your wheels are coplanar:
1. Make the "Coplanarity Gauge" shown in
Figure 62. Note: For best results, straighten
the 2x4 with a jointer before cutting.
2. Remove the fence and table, then open both
wheel covers.
3. Make sure the guide blocks and rear sup-
port bearings are away from the blade, then
tighten your blade to the tension that it will be
used during operation.
4. Place your coplanarity gauge up against both
wheels in the positions shown in
Figure 63.
Coplanarity
Gauge
Gauge Positions
Tracking
Knob
Adjustment
Hub
Wheels
Figure 63. Checking for coplanarity.