Filter
Top Products
G0513X/G0514X/G0514X3 Extreme Series Bandsaw
-23-
The positive stop allows the table to be quickly
and accurately returned to the horizontal (0˚)
position after being adjusted to a different angle.
Components and Hardware Needed: Qty
Hex Bolt M8-1.25 x 90 ....................................... 1
Hex Nut M8-1.25 ...............................................
1
To install the positive stop:
1. Thread the M8-1.25 hex nut halfway onto
the M8-1.25 x 90 hex bolt (this is the positive
stop bolt).
2. Thread the positive stop bolt into the thread-
ed hole on bandsaw body as shown in
Figure 19.
Positive Stop
Personal injury or death
can occur if the bandsaw
starts during table adjust
-
ments. Disconnect power
from the bandsaw before
performing table adjust
-
ments.
Figure 19. Installed positive stop bolt.
Positive Stop
Figure 18. Blade tracking controls.
Blade Tracking
Knob
Lock Lever
5. Loosen the lock lever (Figure 18) so that the
blade tracking knob can rotate.
NOTICE
Changes in the blade tension may change
the blade tracking.
6. Spin the upper wheel with one hand and
rotate the tracking control knob with the other
hand to make the blade rides in the center of
the bandsaw wheel tire.
7. Tighten the tracking control lock knob and
close the upper wheel cover.
For the best performance from your saw, regularly
maintain proper tracking of the blade.