Filter
Top Products
-8-
G0529 Oscillating Spindle & Disc Sander
The Model G0529 Oscillating Spindle & 12" Disc
Sander was carefully packed at the factory. If you
discover the machine is damaged after you have
signed for delivery, and the truck and driver are
gone, you will need to file a freight claim with the
carrier. Save the containers and all packing mate-
rials for possible inspection by the carrier or its
agent. Without the packing materials, filing a
freight claim can be difficult. If you need assis-
tance determining whether you need to file a
freight claim, or with the procedure to file one,
please contact our Customer Service.
When you are completely satisfied with the condi-
tion of your shipment, you should inventory its
parts.
DESCRIPTION Qty
A. Sander unit ........................1
B. Left and Right Side Panels............2
C. Front and Pear Panels ...............2
D. Miter Gauge Assembly ...............1
E. Spindle Assemblies
• 2" ..............................1
• 1
1
⁄2" ............................1
•
5
⁄8 " .............................1
•
1
⁄4 " .............................1
F. Table Inserts
• Oval Table Insert 2" ................1
• Table Insert 2" ....................1
• Oval Table Insert
3
⁄4" ...............1
• Table Insert
3
⁄4"....................1
G. Rubber Floor Pads
• Flat Head Screws
5
⁄16"-18 x
3
⁄4"........4
• Washers
5
⁄16"......................4
• Nuts
5
⁄16" ........................4
H. Wrench Hardware Bag
• Open End Wrench 17mm ...........2
• Open End Wrench 12mm ...........1
I. Hardware Bag
• Hex Bolts
5
⁄16"-18 x
3
⁄4" ..............8
• Hex Nuts
5
⁄16"-18..................10
• Lock Washers
5
⁄16"................10
• Washers
5
⁄16".....................18
• Hex Bolts
5
⁄16"-18 x 1
1
⁄4" .............2
• Hex Key 6mm.....................1
Figure 3. G0529 inventory.
The Model G0529 is a
heavy machine. Personal
injury could occur if the
machine is moved with-
out additional assis-
tance. Seek help when
moving or lifting the
machine.
Sharp edges on metal
parts may cause person-
al injury. Examine the
edges of all metal parts
before handling.
B
E
C
A
F
D
H
G
I
Parts InventoryUnpacking
SECTION 5: SET UP