Filter
Top Products
G0529 Oscillating Spindle & Disc Sander -15-
The table must be spaced evenly away from the
face of the sanding disc so that the sandpaper
does not rub against the table.
To align the table:
1. Loosen the bolts that secure the table to the
table support bracket.
2. Align the table so that there is a
1
⁄16'' gap
between the 12" disc and the table.
3. Tighten the bolts loosened in Step 1.
4. Spin the disc by hand to check if the sandpa-
per is touching the table. Note—DO NOT turn
the disc sander on at this point.
5. Repeat Steps 1-3 if the sandpaper touches
table at any point in the rotation.
Aligning Table
Figure 13. Installing PSA sanding disc.
Sanding Disc
Installation
The disc sander requires 12" PSA (pressure sen-
sitive adhesive) sanding discs.
To install a new sanding disc on the 12" disc
sanding surface:
1. Disconnect the machine from the power sup-
ply.
2. Remove the disc sanding table.
3. Remove the old sanding disc.
4. Install the new sanding disc as shown in
Figure 13.