Filter
Top Products
G0529 Oscillating Spindle & Disc Sander -17-
Damage to your eyes, lungs, and ears could
result from failure to wear safety glasses, a
respirator, and hearing protection while
sanding with this machine.
Loose hair and clothing
could get caught in
machinery and cause
serious personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
This section covers basic disc sanding opera-
tions. Please read the remaining portion of the
manual before attempting any type of operation.
Your safety is important! Please follow the
warnings below during this entire section:
Operating this equipment has the potential
to propel debris into the air which can
cause eye injury. Always wear safety glass-
es or goggles when operating equipment.
Everyday glasses or reading glasses only
have impact resistant lenses, they are not
safety glasses. Be certain the safety glass-
es you wear meet the appropriate standards
of the American National Standards Institute
(ANSI).
The Model G0529 sander is equipped with a
paddle-type power switch with a safety key.
To operate the power switch:
1. Insert the safety locking key shown in Figure
16.
Figure 16. On/Off Switch.
2. Lift the switch to start and press to stop the
motor.
3. Remove the locking key when the machine is
not in use and store the key in a safe place.
Make sure the power switch is in the OFF
position before connecting the sander to the
power source. Serious personal injury could
occur if you connect your machine to the
power source with the power switch ON.
Power Switch
General
SECTION 6: OPERATIONS