Filter
Top Products
G0529 Oscillating Spindle & Disc Sander -11-
Beginning Assembly
Loose hair and clothing
could get caught in
machinery and cause
serious personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Serious personal injury
could occur if you con-
nect your machine to the
power source before you
have completed the
assembly process. DO
NOT connect the machine
to the power source until
instructed to do so.
Sharp edges on metal
parts may cause personal
injury. Examine the edges
of all metal parts before
handling.
This section will cover the basic assembly and
adjustment instructions needed to begin opera-
tion. Complete the assembly in the order provided
in this manual and then read the remaining por-
tion of the manual before attempting any type of
operation.
Your safety is important! Please follow the
warnings below during this entire section:
Cabinet Assembly
Figure 4. Assembled panels.
Figure 5. Installing rubber feet.
The Model G0529 Sander mounts on a sturdy
cabinet stand.
To assemble the cabinet stand:
1. Connect all four panels together with the
5
⁄16"
-18 x
3
/4" hex bolts, lock washers, washers
and hex nuts (Figure 4).
2. Using the
5
⁄16" flat head screws,
5
⁄16" washers
and nuts, install the four rubber feet as
shown in Figure 5.