Filter
Top Products
-14-
G0550/G0551 15" Planer
Loose hair and clothing
could get caught in
machinery and cause
serious personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Sharp edges on metal
parts may cause person-
al injury. Examine the
edges of all metal parts
before handling.
This section covers the basic assembly and
adjustment instructions needed to begin opera-
tion. Complete the assembly in the order provid-
ed in this manual and then read the remaining
portion of the manual before attempting any type
of operation.
Your safety is important! Please follow the
warnings below during this entire section:
Disconnect power to
the machine during the
entire assembly
process. Failure to do
this may result in seri-
ous personal injury.
Components and Hardware Needed: Qty
Legs ..............................................................4
Lower Braces ................................................4
Predrilled Upper Braces ..............................4
Carriage Bolts
5
⁄16"-18 x
1
⁄2" ........................32
Hex Nuts
5
⁄16"-18..........................................32
Flat Washers
5
⁄16" ........................................32
Tools Needed:
12/14mm Combo Wrench ............................1
Note—The following steps are for the G0550
only.
To assemble the open stand:
1. Connect the lower and upper braces to the
legs of the stand with the carriage bolts, hex
nuts and flat washers. See Figure 7.
Figure 7. Upper and lower braces
connected to leg.
G0550 Open Stand Beginning Assembly