Filter
Top Products
-18-
G0550/G0551 15" Planer
Figure 14. Knife setting jig.
Components and Hardware Needed: Qty
Knife Jig Shaft ................................................1
Knife Jig Feet..................................................2
E-Clips 9mm ..................................................4
To assemble the knife setting jig:
1. Snap one of the E-clips over the notch on
one end of the knife setting shaft.
2. Slide the cast aluminum knife setting jig feet
onto the rod.
3. Snap the other E-clip onto the notch at the
other end of the knife setting jig shaft.
Jig Feet
E-Clip
Jig Shaft
Knife Setting Jig