Filter
Top Products
G0550/G0551 15" Planer -17-
Figure 13. Checking extension roller alignment..
Figure 12. Bed roller.
5. Loosen the bed roller setscrews and turn the
eccentric shaft so the table rollers are
beneath the table surface. See Figure 12.
6. Use a straightedge to check table-to-exten-
sion roller alignment as shown in Figure 13.
7. Adjust the leveling setscrews shown in
Figure 11 if the table and extension rollers
are not flush.
Components and Hardware Needed: Qty
Extension Rollers ..........................................2
Tools Needed:
12/14mm Combo Wrench ..............................1
Allen Wrench 4mm ........................................1
To install the extension rollers:
1. Do not connect the planer to a power
source!
2. Remove the three hex bolts and washers
from below the outfeed and infeed tables.
3. Position the extension rollers over the holes.
4. Finger-tighten the hardware removed in step
2 to secure the extension rails to the planer
as shown in Figure 11.
Figure 11. Extension rollers.
Hex Bolts
Level Adjust
Setscrews
Setscrews
Extension Rollers