Filter
Top Products
-28-
G0550/G0551 15" Planer
Always disconnect
power to the machine
before performing ser-
vice adjustments. Failure
to do this may result in
serious personal injury.
This section is designed to help the operator with
adjustments that were made at the factory and
that might also need to be made during the life of
the machine.
This section is provided for your convenience—it
is not a substitute for the Grizzly Service
Department. If any adjustments arise that are not
described in this manual, then feel free to call the
Grizzly Service Department at (570) 546-9663.
Similarly, if you are unsure of how to perform any
procedure in this section, the Grizzly Service
Department will be happy to guide you through
the procedures or help in any other way.
Before attempting to adjust the table, you will
need to construct a gauge block. See Figure 26.
Do not use common 2x4 material. Use a hard
wood material like maple or oak. A pattern for this
gauge block has been provided for you on page
48 of this manual.
A good alternative is to use a Rotocator Figure
27. Use the Rotocator whenever the instructions
call for use of the gauge block or feeler gauge.
Refer to the current Grizzly catalog for rotocators.
Figure 26. Gauge block specifications.
Figure 27. Rotocator.
Gauge Blocks
About Service
SECTION 8: SERVICE ADJUSTMENTS