Blade Center
Tra cking
Wheel Alignment Page 49
Note: Changes in the blade tension may change
the blade tracking. For best performance, regularly
check and maintain the proper blade tracking.
To center track the blade:
1.
2.
Adjusting
Blade Guide Bearings
Note: When adjusting the blade tracking, the
blade must have a reasonable amount of ten-
sion to simulate operating conditions. After
the Test Run is successfully completed, you
will perform a thorough version of the follow-
ing steps to correctly tension the blade.
3.
4.
5.
If the blade rides on the center of
the crown
Step 9
If the blade does not ride on the center
of the crown,
Figure 23.
Figure 22.