Figure 24.
Dust Collection
DO NOT operate this bandsaw without an ade-
quate dust collection system. This bandsaw
creates substantial amounts of wood dust
while operating. Failure to use a dust collec-
tion system can result in short and long-term
respiratory illness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
6.
Note: The blade tracking adjustment knob
controls the tilt of the upper wheel which,
in turn, controls the center tracking of the
blade.
7.
8.
9.
Note: For the best performance from your saw,
regularly maintain the proper tracking of the
blade.
To connect a dust collection hose:
1.
2.
Note: A tight fit is necessary for proper per-
formance.