Filter
Top Products
G0609 12" Parallelogram Jointer
-41-
The fence stops simplify the task of adjusting the
fence to 45˚ inward, 90˚, and 45˚ outward (135˚).
Tools Needed Qty
45° Square ........................................................ 1
90° Square ........................................................
1
Sliding Bevel ......................................................
1
Wrench 14mm ...................................................
1
To set the 45˚ inward fence stop:
1. Tilt the fence approximately 45° inward
(Figure 57) onto the positive stop bolts using
a square
.
3. Adjust the positive stop bolts until the fence is
exactly 45° inward while resting on the bolts
(verify the angle with a 45° square)
.
4. Retighten the jam nut loosened in Step 2.
Setting Fence Stops
Figure 57. Fence adjusted 45˚ inward.
2. Loosen the jam nut on the 45° inward positive
stop bolt shown in
Figure 58.
Figure 56. Depth scale adjusted to “0” position.
Figure 55. Infeed table even with outfeed table.
4. Using a screwdriver, adjust the scale pointer
to "0" (
Figure 56), then reset the infeed
table positive stops.
The depth scale on the infeed table can be cali
-
brated or "zeroed" if it is not correct.
Tools Needed Qty
Straightedge ...................................................... 1
Phillips Screwdriver ...........................................
1
Wrench 17mm ...................................................
1
Hex Wrench 5mm ..............................................
1
To calibrate the depth scale:
1. DISCONNECT JOINTER FROM POWER
SOURCE!
2. Loosen the infeed table positive stop bolts.
3. Use the straightedge to help adjust the infeed
table exactly even with the outfeed table, as
shown in
Figure 55.
Calibrating Depth
Scale
45° Inward
Positive Stop
Bolt
Figure 58. 45° inward positive stop bolt (one of
two shown).
Jam Nut