Filter
Top Products
-22-
G0656 8" Jointer with Built-In Mobile Base
Squaring stock involves four steps performed
in the order below:
1. Surface Plane On The Jointer—The con
-
cave face of the workpiece is surface planed flat
with the jointer.
Previously
Jointed Edge
Previously
Surface
Planed Face
2. Surface Plane On a Thickness Planer—The
opposite face of the workpiece is surface planed
flat with a thickness planer.
3. Edge Joint On The Jointer—The concave
edge of the workpiece is jointed flat with the
jointer.
4. Rip Cut On A Table Saw—The jointed edge
of the workpiece is placed against a table saw
fence and the opposite edge cut off.
Squaring Stock
The purpose of surface planing on the jointer is
to make one flat face on a piece of stock (see
Figures 26 & 27). This is a necessary step when
preparing a workpiece to be run through a planer
when squaring stock.
NOTICE
If you are not experienced with a jointer,
set the depth of cut to 0", and practice
feeding the workpiece across the tables as
described. This procedure will better pre
-
pare you for the actual operation.
Figure 27. Illustration of surface planing results.
Figure 26. Typical surface planing operation.
Surface Planing