Filter
Top Products
-36-
G0656 8" Jointer with Built-In Mobile Base
Figure 56. Infeed table adjusted even with
outfeed table.
6. Using a screwdriver, adjust the scale pointer
exactly to “0”, as shown in
Figure 57.
Setting Infeed Table
Figure 55. Positive stop bolts for infeed table.
Top Height
Bottom Height
Figure 57. Depth stop lever set at "0".
Depth Stop
Lever
Jam Nut
Stop Bolt
Top Pin
The infeed table height is set by calibrating the
depth scale, and adjusting the positive stop bolts
and depth stop lever.
Tools Needed Qty
Straightedge ...................................................... 1
Phillips Head Screwdriver .................................
1
Wrench 14mm ...................................................
1
Hex Wrench 4mm ..............................................
1
Calibrating Depth Scale
The depth scale on the infeed table can be cali-
brated or "zeroed" if it is not correct.
1. Set the outfeed table height as described in
Setting Outfeed Table Height on Page 17.
2. Move the cutterhead guard out of the way.
3. Loosen the jam nut on the top height positive
stop bolt (Figure 55) and raise the bolt so it
does not obstruct the infeed table when it is
raised in Step 5
.
4. Place a straightedge across the infeed and
outfeed tables.
5. Adjust the infeed table until it is level with the
outfeed table, as illustrated in
Figure 56.
Positive Stop Bolts
The infeed table has positive stop bolts that allow
the operator to quickly adjust the infeed table
between finish/final cuts and shaping/heavy cuts.
We recommend setting the minimum depth of cut
to
1
⁄32" and the maximum depth of cut to
1
⁄8" for
most operations. DO NOT exceed
1
⁄8" cut per
pass on this machine or kickback and serious
injury may occur!
Each positive stop bolt (Figure 55) controls the
top or bottom range of the table movement. The
jam nuts lock the positive stop bolt in position so
it won't move during operation.
Depth Stop Lever
A depth stop lever (Figure 57) above the depth
scale allows the operator to set the maximum
depth of cut to
1
⁄8".
To engage the lever, position it as shown in Figure
57. To disengage the lever, raise the table to "0",
then raise and hold the lever against the top pin
while lowering the table to the desired height.
Bottom Pin