Filter
Top Products
Loading/Unloading
To o li n g
Figure 42
Tools Needed Qty
Loading Tooling
1.
2.
3.
4.
5.
Figure
43
Figure 43.
6.
Note: Over-tightening the drawbar could
make removing the tool difficult.
Unloading Tooling
1.
2.
3.
Note: If the tool does not immediately release
from the spindle when the drawbar is first
loosened, you may need to tap the top of the
drawbar with a dead-blow hammer or rubber
mallet.
Cutting tools are sharp and can quick-
ly injure your hands. Always protect your
hands when handling cutting tools.
Figure 42.