Filter
Top Products
6.
Figure 7
Note: The tool post mounting hole of the
grinder will accept tool post studs up to 1" in
diameter. However, if the diameter or height
of your tool post stud allows for side-to-side
or up-and-down movement of the grinder
when the nut is fully tightened, you will need
to fabricate a custom bushing for the tool
post.
Unexpected movement of the grinder on
the tool post stud could cause the grinding
wheel to break apart and become an injury
hazard. Always make sure the grinder is
firmly secured to the tool post stud so that
there is no side-to-side or up-and-down
movement.
7.
Figure 7.
Adjusting Grinder
Spindle Centerline
Figure 5
Page 12
Tools Needed Qty
To adjust the grinder spindle centerline
height:
1.
2.
Figure 8
3.
Note: The numerical increments on the eleva-
tion wheel are for your reference only and do
not indicate the actual height of the spindle.
4.
Figure 8.