Grizzly G0688 Grinder User Manual


  Open as PDF
of 44
 


9. Figure
17     

 

Figure 17.










10. 
Figure 17
Note: Use the belt tensioning knob to adjust
the belt tension just enough so that it stays on
the pulleys when rotated.
11. 


Step 9


6.        Step 5
 Page 17     
Figure 16

Figure 16.



7. 


Note: If the tapered mating surfaces are not
thoroughly clean, it could be extremely dif-
ficult to remove the pulley.
8.      
       
      
Step 5
Note: There are two internal spindle pul-
leys—the larger one is for a grinder spindle
speed of 16,500 RPM, and the smaller one is
for a speed of 23,000 RPM. Use the one that
best fits your operation.
 previous next