Filter
Top Products
-10- G1023Z Series Heavy-Duty 10'' Table Saw
G1023ZX3
Figure 7. NEMA-style L15-20 plug and outlet.
The motor supplied with the Model ZX3 is a 5 HP
220V 3-phase motor. Under normal 220V use, the
motor draws approximately 15 amps. Use a 20
amp circuit breaker or a 20 amp slow-blow fuse
for 220V operation.
The Model ZX3 does not come with a plug. When
operating at 220V, use a NEMA-style L15-20 plug
and receptacle as shown in Figure 7.
The circuit you use should be dedicated, (i.e., the
machine should provide the only draw from that
circuit). If frequent circuit failures occur when
using this machine, contact our Service
Department or your local electrical contractor.
If the machine is not wired correctly a fire
could result. Make sure your wiring, recep-
tacle, plug, and circuit breaker can handle
the current draw of the machine. If you are
not sure that your electrical circuit can han-
dle the current draw, get a qualified electri-
cian to test your electrical system and do
any required upgrades. DO NOT attempt to
modify an existing circuit by only replacing
the circuit breaker with one rated for a high-
er amperage draw than the wiring, recepta-
cle, and plug are rated for.