Filter
Top Products
G1023Z Series Heavy-Duty 10'' Table Saw -35-
1. Disconnect the machine from the power
source!
2. Cut a piece of wood that is as long and tall as
the metal fence and
3
⁄4" thick. This will be the
sacrificial fence. Make sure the wood is a
uniform thickness and free of knots and
defects.
3. Attach the sacrificial fence to the metal fence
with screws or clamps.
4. Remove the blade guard/splitter assembly,
the table insert, and the regular saw blade
from the arbor.
5. Install and adjust the dado blade system as
recommended in the dado blade instructions.
6. Adjust the saw blade to maximum height
needed for the rabbeting operation.
7. Raise the blade an additional
1
⁄4".
8. Slide the metal fence with the attached sac-
rificial fence along side the blade.
9. Using a felt pen, draw the blade profile onto
the sacrificial fence.
10. Remove the sacrificial fence from the metal
fence.
11. Using a bandsaw or jig saw, cut the marked
blade profile from the sacrificial fence.
12. Re-attach the sacrificial fence to the metal
fence with screws or clamps.
13. Slide the fence assembly over the saw blade.
The blade should NOT touch the sacrificial
fence.
Cutting rabbets with the dado blade:
1. Adjust the saw blade to the maximum height
needed for the rabbeting operation.
Never perform a through cut operation with
a dado blade. A dado blade was designed to
make non-through cuts only. Failure to fol-
low this warning could result in serious per-
sonal injury.
2. If rabbeting along the long length of your
workpiece, adjust the distance between the
fence and the workpiece to suit your needs
as shown in Figure 36.
Figure 36. Rabbet cutting.