Filter
Top Products
-12- G1023Z Series Heavy-Duty 10'' Table Saw
SECTION 4: MACHINE FEATURES
The following is a list of common definitions,
terms and phrases used throughout this manual
as they relate to this table saw and woodworking
in general. It is important that you read and
become familiar with them before assembling,
adjusting or operating this machine. Your safety
is VERY important to us at Grizzly!
Arbor: Metal shaft extending from the drive
mechanism, to which the cutting blade is
attached.
Bevel Edge Cut: Tilting the saw arbor and blade
to an angle between 0° and 45° to perform an
angled cutting operation.
Blade Guard: Metal or plastic mechanism that
mounts over the saw blade to prevent acciden-
tal contact with the cutting edge.
Crosscut: Table saw operation in which the miter
gauge is used to cut across the grain of a piece
of wood.
Dado Blade: Blade or set of blades that attach to
the arbor and are used for cutting grooves and
rabbets.
Dado Cut: Table saw operation that uses a dado
blade to cut a flat bottomed groove into the
face of wood stock.
Featherboard: Safety device used to keep the
workpiece against the rip fence or table during
a cutting operation. The featherboard also
allows the operator to keep his/her hands at a
safe distance away from the saw blade while
cutting the workpiece.
Terms & Definitions
Kerf: The resulting cut or gap made by a saw
blade.
Kickback: A condition in which the wood is
thrown back towards an operator at a high rate
of speed.
Miter Gauge: A component that controls the
wood stock movement while performing a
crosscut. Allows for variation of angle cuts
such as miter cuts used on a picture frame.
Moulding Head: A cutterhead attached to the
arbor that accepts interchangeable moulding
knives for profile cutting. We DO NOT recom-
mend the use of moulding head cutters.
Parallel: Being an equal distance apart at every
point. i.e. the rip fence face is parallel to the
side face of the saw blade.
Non-Thru Cut: A sawing operation that requires
the removal of the blade guard and splitter.
Dado and rabbet cuts are considered Non-
Thru Cuts because the blade does not pro-
trude above the top face of the wood stock.
Always remember to reinstall the blade guard
and splitter after performing a non-thru cut.
Perpendicular: Intersecting and forming right
angles; at right angles to the vertical and hori-
zontal planes. i.e. the blade is perpendicular to
the table surface.
Push Paddle: Safety aid used to push a piece of
wood stock through a cutting operation.
Push Stick: Safety aid used to push a piece of
wood stock through a cutting operation.
Usually used when rip cutting.
Rabbet: Cutting operation that creates an L-
shaped channel along the edge of wood stock.