Filter
Top Products
G1531 Edge Sander -9-
FFiigguurree 44..
Lead screw bracket Installed.
FFiigguurree 55..
Installing the horizontal brace.
FFiigguurree 77..
Horizontal/Vertical brace installed.
WWoorrkkiinngg TTaabbllee
11..
Bolt the lead screw bracket to the front of the
stand using the four Hex Bolts already
threaded in place.
FFiigguurree 44..
22..
Thread the horizontal brace into position, but
do not tighten it down; the brace will require
further adjustment later on.
FFiigguurree 55..
FFiigguurree 66..
Installing the lead screw assembly.
33..
Locate the lead screw / table bracket assem-
bly and the handwheel. Thread the hand-
wheel onto the lead screw about halfway and
insert the lead screw into the lead screw
bracket.
FFiigguurree 66..
44..
Locate the vertical brace and remove the top
Hex Nut and Flat Washer.
55..
Turn the horizontal brace approximately 45˚
and insert the vertical brace through the hole
at the end of the horizontal brace. Rotate the
horizontal/vertical brace assembly to 90˚.
66..
Insert the threaded end of the vertical brace
through the hole in the bottom of the table
bracket and re-install the Flat Washer and
Hex Nut back onto the shaft.
FFiigguurree 77..