Filter
Top Products
-14- G1531 Edge Sander
BBeelltt TTrraacckkiinngg
SSEECCTTIIOONN 33:: AADDJJUUSSTTMMEENNTTSS
FFiigguurree 1188..
Belt tracking adjustment knobs.
11..
Carefully move the belt left to right by hand
and adjust the tracking knob as necessary to
achieve proper tracking.
FFiigguurree 1188..
22..
Before beginning this step, read the
SSaaffeettyy
RRuulleess
on page
1177
and
TTeesstt RRuunn
on page
1188..
Connect to power and turn the machine on
and off quickly. If the belt appears to track
OK turn the machine on and fine tune the
tracking. Tighten the tracking lock knob.
AAuuxxiilliiaarryy TTaabbllee
FFiigguurree 1199..
Auxiliary table positioning.
Loosen the thumb screws, position the auxiliary
table, re-tighten the thumb screws.
FFiigguurree 1199..
Note that the ends of the roller are tapered. This
helps keep the belt tracked. When using the end
roller for curved sanding, we recommend you use
the center portion of the roller to assure proper
belt tracking. This also prevents the edge of the
workpiece from becoming tapered.
Locking Knob
Adjustment Knob