Filter
Top Products
G1531 Edge Sander -15-
BBeelltt TTeennssiioonn
FFiigguurree 2222..
Belt tensioning mechanism.
Belt tension is preset at the factory and usually
requires no adjustment. If the need to increase
the tension should occur, unthread the retaining
nut (arrow) at the end of the idler roller mounting
shaft.
FFiigguurree 2222..
Do not unthread the nut more
than
1
⁄
2 its length. If tension problems persists,
call the service center for further help.
TTaabbllee TTiilltt
FFiigguurree 2200..
Lock handle underneath the table.
11..
Loosen the lock handles, tilt the working
table to the desired angle and retighten the
lock handles.
FFiigguurree 2200..
22..
It may be necessary to re-adjust the working
table closer to the platen. Not more than a
1
⁄4'' gap should exist between the platen and
the working table.
TTaabbllee HHeeiigghhtt
FFiigguurree 2211..
Table height adjustments.
11..
Loosen lead screw lock handle and stabiliz-
ing shaft lock bolt.
FFiigguurree 2211..
22..
Turn hand wheel and position working table
to desired height.
33..
Retighten lock handle and lock bolt.