Filter
Top Products
-10- G1531 Edge Sander
FFiigguurree 88..
Checking table bracket for parallelism.
FFiigguurree 99..
Table trunnions installed.
77..
Measure the table bracket to the stand to
assure it is parallel to the stand.
FFiigguurree 88..
If
the bracket is not parallel, remove the verti-
cal brace, thread the horizontal brace in or
out an appropriate amount and reinstall the
vertical brace.
FFiigguurree 1100..
Attaching the working table.
1100..
Leaving the table trunnion lock handles
slightly loose, bolt the working table to the
trunnions using the two
5
⁄
16''-18 x
3
⁄
4'' Hex
Bolts and
5
⁄
16'' Flat Washers supplied.
FFiigguurree
1100..
Adjust the table so it is approximately
1
⁄8''
to
3
⁄
16'' from the edge of the sanding platen
and tighten the mounting bolts.
FFiigguurree 1111..
Setting the pointer to 90˚.
1111..
Adjust the work table 90˚ to the sanding plat-
en by checking it with a square. Adjust as
necessary and tighten the table lock han-
dles. At this point adjust the pointer to 90˚.
FFiigguurree 1111..
88..
Once the table bracket has been properly
adjusted, tighten the horizontal brace jam
nut and the two Hex Nuts that hold the verti-
cal brace in place.
99..
Attach the table trunnions to the table brack-
et. Each is held in place with a
3
/8'' Flat
Washer and lock handle.
FFiigguurree 99..
The trun-
nion with the scale attaches to the left side.