Filter
Top Products
-18-
G7947/G7948 12 Speed Floor Drill Press
Figure 6. Column secured to base.
Components and Hardware Needed: Qty
Base ...................................................................
1
Column ...............................................................
1
Hex Bolts M12-1.75 x 45 .....................................
4
The column must be secured on the base to
properly assemble your drill press.
To secure the column to the base:
1. Place the column on the base and align the
mounting holes.
2. Secure the column to the base with the four
hex bolts, as shown in Figure
6.
Table Support
Components and Hardware Needed: Qty
Table Support Assembly ...................................
1
Pinion .................................................................
1
Crank Handle ....................................................
1
Handle ...............................................................
1
Large Lock Lever ...............................................
1
Small Lock Lever ...............................................
1
The table support must be installed as described
to properly assemble your drill press.
To install the table support:
1. Place the pinion in the table support, as
shown in Figure
7, so the pinion and gear
teeth mesh together.
Figure 7. Pinion correctly installed in table
support.
Column and Base