Filter
Top Products
-22-
G7947/G7948 12 Speed Floor Drill Press
Figure 16. Seating arbor into chuck.
Tang-Side
Up
Figure 18. Downfeed handles and belt cover
knob installed.
Components and Hardware Needed: Qty
Downfeed Handles .............................................3
The downfeed handles must be installed to prop
-
erly operate the drill press.
To install the downfeed handles:
1. Thread the handles into the spindle hub, as
shown in Figure 18, and tighten.
2. Remove the screw that fastens the belt cover
in place and install the belt cover knob in its
place (see Figure 18 for location).
Downfeed Handles &
Belt Cover Knob
DO NOT use a steel hammer on the drill
chuck to seat the arbor into the spindle.
You will damage the chuck and/or spindle,
which may make them unusable or unsafe.
Figure 17. Seating arbor and chuck into spindle.
4. Slide the arbor into the spindle socket while
slowly rotating the drill chuck. The socket has
a rectangular pocket where the tang (or flat
portion of the arbor shown in
Figure 16) fits
into.
5. Seat the chuck with a rubber mallet, as shown
in Figure 17.
Belt Cover
Knob
Spindle
Hub