Filter
Top Products
-10- G8220 Wet/Dry Bench Grinder
Tool Rest-Wet Wheel
The large horizontally mounted wet grinding
wheel also has a tool rest situated over it to aid
the user in the grinding operations:
1. Position the two support brackets in the
wide grooves which are located on each
side of the water tray. The recess in the
shape of a half circle should be facing out-
ward on each side. See Figure 4.
Figure 4. Mounting rest holder.
Figure 5. Mounting tool rest.
2. Thread a locking knob with washer through
the hole in the bottom of the holder and into
the water tray body. These knobs control
the overall height of the tool rest assembly.
3. Set the tool rest into the half circle recess-
es. The sliding tool rest should already be
assembled onto the holder, if it is not, slide
the tool rest into the groove. It only goes
one way as there is a tab preventing incor-
rect installation. The miter gauge also
should already be positioned on the sliding
tool rest.
4. Attach the tool rest assembly to the support
brackets. Using the M4-.7 x 30mm Hex
Head Bolt, push the bolt through from the
inside of the holder and secure a knob to it
on the outside. See Figure 5. These two
knobs control the angular adjustment of the
tool rest. The hex heads will lock into a
recess molded into the inside of the brack-
et.