Filter
Top Products
G8976 3 Wheel 12" Bandsaw -13-
Beginning Assembly
Loose hair and clothing
could get caught in
machinery and cause
serious personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Serious personal injury
could occur if you con-
nect your machine to the
power source before you
have completed the
assembly process. DO
NOT connect the
machine to the power
source until instructed to
do so.
!
Sharp edges on metal
parts may cause person-
al injury. Examine the
edges of all metal parts
before handling.
This section will cover the basic assembly and
adjustment instructions needed to begin opera-
tion. Complete the assembly in the order provid-
ed in this manual and then read the remaining
portion of the manual before attempting any type
of operation.
Your safety is important! Please follow the
warnings below during this entire section:
Base Feet
To attach the base feet to the bandsaw:
1. Remove the four knob bolts from the side
cover (Figure 5).
2. Attach the base feet to the bottom of the
bandsaw with the M8-1.25 x 25 hex bolts and
the M8-1.25 hex nuts (Figure 6). Note—The
hex bolts extend up through the bottom of
the feet, and through the bottom of the band-
saw, where they are secured with the hex
nut.
Figure 5. Removing the side cover knob bolts.
Figure 6. Base foot attached to the bandsaw.
!