Filter
Top Products
-14-
G8976 3 Wheel 12" Bandsaw
To attach the table to the bandsaw:
1. Loosen the screw that secures the miter bar
to the table (Figure 7). DO NOT remove the
screw.
2. Slide the miter bar keyhole notch (Figure 7)
off of the screw loosened in step 1.
3. Loosen and remove the phillips screw in the
blade slot of the table (Figure 8).
4. Loosen the hex nuts on the four phillips
mounting screws (Figure 9).
5. Remove the knob bolts that secure the trun-
nion to the saw and set the trunnion aside
(Figure 10).
6. Remove 2 of the 4 hex nuts from the phillips
mounting screws and slide the trunnion onto
the bottom of the table (Figure 11).
Figure 7. Loosening the screw that secures the
miter bar to the table.
Figure 8. Phillips screw removed from table.
Figure 9. Loosening the mounting screws.
Figure 10. The trunnion knob bolts.
Figure 11. Sliding the trunnion onto the table.
Table
Keyhole
Notch